Metra MITO-01 Installationshandbuch PDF herunterladen

MITSUBISHI DATA BUS INTERFACE

1-800-221-0932

www.axxessinterface.com

MITO-01

INSTALLATION INSTRUCTIONS

1-800-221-0932

www.axxessinterface.com

MITO-01 MITO-01

INTERF

ACE COMPONENTS

• MITO-01 Interface

• 14 Pin Harness with RCA’s

• Vehicle side harness

• 2 Pin harness

Rev. 03/11/10 INSTMITO-01

* READ IMPORTANT WARNING ON PAGE 2

BEFORE ATTEMPTING ANY INSTALLATION

The MITO-01 is designed to be used in vehicles listed in

the applications that have the Rockford Fosgate audio sys-

tem.The Rockford Fosgate system uses a digital signal to

turn on the amplifier. The MITO-01 supplies that digital sig-

nal to turn the amplifier on and also eliminates the “COM

ERROR” message on the display when the OEM radio is

removed. When installing a radio that has navigation built

in, the MITO-01 can supply VSS (Vehicle Speed Sense),

Parking Brake, and Reverse; however Reverse is not avail-

able on manual transmission vehicles.

The radios speaker wires will provide the audio for the

dash and rear speakers while the rca’s will provide the

audio to the amplifier to power the door speakers and

woofer.

INSTALLING AND TESTING THE MITO-01

1. With all connections completed to the radio, plug the corresponding harnesses

into the MITO-01.

2. Cycle the key by turning the ignition on then back off, then back on again to

test the radio for proper operation.

3. If the subwoofer or front door speakers are too loud you can adjust the output

by follo

wing the steps below:

A. Locate the end of the MITO-01 with the 14 way Molex connector.

B. There are 2 potentiometers next to the Molex connector, the one closest to the

Molex connector is the subwoofer control and the other one is the front door

speaker control.

C. Using a small blade screwdriver turn the potentiometer of the speaker you want

to adjust either clockwise to make it louder or counterclockwise to lower the

volume.

SUBWOOFER CONTROL

FRONT DOOR SPEAKER

CONTROL

NOWLEDGE IS

OWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

1 2

MITO-01 MITO-01 1
* IMPORTANT WARNING 2

Inhaltsverzeichnis

Seite 1 - MITO-01 MITO-01

Seite 2 - * IMPORTANT WARNING

3MITO-01TOOLS REQUIRED FOR INSTALLATION• Cutting Tool • Small Blade Screwdriver • Tape • Crimping Tool • Connectors(I.E. butt-connectors, bell caps,

Kommentare zu diesen Handbüchern

Keine Kommentare

Metra MITO-01 Installationshandbuch

Stöbern Sie online oder laden Sie Installationshandbuch nach Auto-Kits Metra MITO-01 herunter. Metra MITO-01 car kit Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto-Kits Metra MITO-01